Gadgets and Technology

 

Well this configuration is about to configure the Gateway by using Cisco Router

Lets have a look towards its configurations


Configuration on Gatekeeper

Gatekeeper(config)#
Gatekeeper(config)# gatekeeper
Gatekeeper(config-gk)# zone local Gatekeeper abc.com
Gatekeeper(config-gk)# no shutdown

Configuration on Gateway Router-A

Router-A(config)#
Router-A(config)#gateway
Router-A(config)#interface Ethernet 0/0
Router-A(config)# h323-gateway voip interface
Router-A(config)# h323-gateway voip id Gatekeeper ipaddr 200.100.10.1
Router-A(config)# h323-gateway voip h323-id Router-A.abc.com
Router-A(config)#exit
Router-A(config)# dial-peer voice 10 pots
Router-A(config-dial-peer)# destination-pattern 1111
Router-A(config-dial-peer)# port 1/0/0
Router-A(config-dial-peer)# exit
Router-A(config)# dial-peer voice 12 voip
Router-A(config-dial-peer)# destination-pattern 2222
Router-A(config-dial-peer)# session target ras
Router-A(config-dial-peer)# exit

Configuration on Gateway Router-B

Router-B(config)#
Router-B(config)#gateway
Router-B(config)#interface Ethernet 0/0
Router-B(config)# h323-gateway voip interface
Router-B(config)# h323-gateway voip id Gatekeeper ipaddr 200.100.10.1
Router-B(config)# h323-gateway voip h323-id Router-B.abc.com
Router-B(config)#exit
Router-B(config)# dial-peer voice 10 pots
Router-B(config-dial-peer)# destination-pattern 2222
Router-B(config-dial-peer)# port 1/0/0
Router-B(config-dial-peer)# exit
Router-B(config)# dial-peer voice 12 voip
Router-B(config-dial-peer)# destination-pattern 1111
Router-B(config-dial-peer)# session target ras
Router-B(config-dial-peer)# exit

Use the show gatekeeper endpoints command on the gatekeeper to verify that the two gateways have registered.

Gatekeeper# show gatekeeper endpoints